Installation - Sharp SJ-FJ676V Operation Manual

Table of Contents

Advertisement

INSTALLATION

WARNING
Do not install the refrigerator in a damp or wet location
as this may cause damage to the insulation and a
leakage. Condensation may also build on the outer
cabinet and cause rust.
1
Keep adequate ventilation space around the refrigerator.
The fi gure shows the minimum
required space for installing
the refrigerator.
The amount of space around
the refrigerator affects
the amount of power
consumption.
Insuffi cient spacing will
decrease cooling effi ciency
and increase energy
consumption.
This may reduce the life of the unit and void warranty.
If using the refrigerator in the smaller space dimension
than the below fi gure, it may cause the temperature
rise in the unit, loud noise and failure.
The space between the rear of the refrigerator and the
wall should be 60mm or more and less than 75mm.
If the space is wider than 75mm, you may get injured
by touching compressor and its peripheral parts which
are extremely hot during the operation.
Overall space
required in use
2
Use the two front adjustable feet, to ensure that the
refrigerator is positioned fi rmly and fl at on the fl oor.
90mm
or more
60mm
60mm
or more
or more
1500 mm
Adjustable foot
3
When right and left doors are not properly aligned, adjust
using the adjustable feet.
When the left door is
raised.
Lower the foot
at right side.
(Until the adjustable foot on the
other side is slightly off-ground.)
4
Remove the 4 screws of the cabinet lower part, and
then set the foot cover (supplied inside the refrigerator
compartment) with removed 4 screws.
Screw
(4 screws)
5
Connect the power plug to a 230/240 volt. 10 amp.
power point.
NOTE
Position your refrigerator so that the plug is accessible.
Keep your refrigerator out of direct sunlight.
Do not place next to heat generating appliance.
Do not place directly on the ground. Provide suitable stand.
If the mains power is switched on when the door is open, the
door alarm will sound. Close the door to stop the alarm.
Before using your refrigerator
Clean the inside parts with a cloth soaked in warm water.
If soapy water is used, wipe it off thoroughly with water.
Free standing type
When the right door is
raised.
Lower the foot
at left side.
Screw
Foot cover
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents