SWR BASS 750 User Manual page 11

The Bass 750 should be mounted as close to the bottom of the rack case as possible. The height of the rub-
ber feet was chosen so that when you slide the unit in the bottom of the rack case, the rack mounting holes
on the front panel will line up with the mounting holes of the rack rail. This prevents the Bass 750 from flexing
downward if the rack case is dropped. If you must mount the Bass 750 in an area of the rack other than the
bottom space, a piece of wood or similar solid material should be installed between the bottom of the rack
case and the bottom of the amplifier to prevent flexing of the amplifier's chassis. Severe or constant flexing of
the chassis can damage the amplifier and is not covered under the warranty.
Don't neglect your amp after it has been installed in a rack case. Continuous transportation and vibration can
cause screws to become loose, both on the Bass 750 and on your rack case rails. We recommend that at
least once a month you remove the Bass 750 from the case and tighten all outside screws (especially on the
front panel). Then check all the connections in your rack case and reinstall the unit.
BASS 750 USER GUIDE • 9