Clarke Devil 350 Operating & Maintenance Instructions
Clarke Devil 350 Operating & Maintenance Instructions

Clarke Devil 350 Operating & Maintenance Instructions

Ceramic heater

Advertisement

Quick Links

CERAMIC HEATER
Model: Devil 350
Part No: 6920262
OPERATING & MAINTENANCE
INSTRUCTIONS
GC11/11rev1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Devil 350 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Clarke Devil 350

  • Page 1 CERAMIC HEATER Model: Devil 350 Part No: 6920262 OPERATING & MAINTENANCE INSTRUCTIONS GC11/11rev1...
  • Page 2: Environmental Protection

    INTRODUCTION Thank you for purchasing this CLARKE Ceramic Heater. Please read this manual thoroughly and follow the instructions carefully. Before attempting to use the heater, thoroughly familiarise yourself with the heater & its operation. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to the heater giving you long and satisfactory service.
  • Page 3: General Safety Rules

    GENERAL SAFETY RULES WORK AREA 1. This heater is for INDOOR USE ONLY. 2. Do not expose the heater or power cable to rain or wet conditions. Any water entering the heater will increase the risk of electric shock. DO NOT use this heater in a bathroom, shower room or any other wet environment.
  • Page 4 6. Check the heater for damage before use. Any damage should be properly repaired or the part replaced. If in doubt, DO NOT use. Consult your local Clarke dealer. SERVICE & REPAIRS 1. If necessary, have your heater repaired by a qualified person using identical replacement parts.
  • Page 5: Electrical Connections

    ELECTRICAL CONNECTIONS WARNING! Read these electrical safety instructions thoroughly before connecting the product to the mains supply. Before switching the machine on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate. This product is designed to operate using 230 VAC mains power.
  • Page 6: Unpacking And Assembly

    UNPACKING AND ASSEMBLY Before assembling, please check contents against the following list and advise your dealer immediately if any parts are missing. 1 x Heater Handle 2 x Legs 1 x Handle 6 x Screws (supplied fitted) 1. Remove the screws from their Screws locations in the heater and use them to attach each leg.
  • Page 7: Cleaning And Maintenance

    DO NOT use abrasive cleaners. Take care that no moisture enters the heater. • Refer to your CLARKE dealer if internal maintenance is required. • When storing the heater, allow it to cool down, then place it for storage in a dry, ventilated place.
  • Page 8: Fault Finding

    FAULT FINDING l l u & , y l l n i y l l u l l r t s l n i . t i . y l Parts & Service: 020 8988 7400/E-mail:Parts@clarkeinternational.com or Service@clarkeinternational.com...
  • Page 9: Component Parts

    COMPONENT PARTS & " 2 Parts & Service: 020 8988 7400/E-mail:Parts@clarkeinternational.com or Service@clarkeinternational.com...
  • Page 10: Technical Specification

    TECHNICAL SPECIFICATION Please note that the details and specifications contained herein, are correct at the time of going to print. However, CLARKE International reserve the right to change specifications at any time without prior notice. A selection of suitable extension leads & plugs is available from your nearest CLARKE dealer, for further information, contact your nearest dealer, or telephone CLARKE International Sales department on 01992 565300.
  • Page 11: Declaration Of Conformity

    DECLARATION OF CONFORMITY Parts & Service: 020 8988 7400/E-mail:Parts@clarkeinternational.com or Service@clarkeinternational.com...

Table of Contents