Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Clarke DEVIL 2800
Summary of Contents for Clarke DEVIL 2800
- Page 1 2.8KW ELECTRIC FAN HEATER MODEL NO: DEVIL 2800 PART NO: 6925800 OPERATION & MAINTENANCE INSTRUCTIONS ORIGINAL INSTRUCTIONS GC0518 ISS 3 This product is not suitable for primary heating purposes. This product is only suitable for well insulated spaces or occasional use.
-
Page 2: Specifications
INTRODUCTION Thank you for purchasing this CLARKE product. Before attempting to use this product, read this manual carefully. In doing so you guarantee the safety of yourself and that of others around you, and you can look forward to your... - Page 3 THE FOLLOWING TABLE ADDRESSES THE INFORMATION REQUIREMENTS OF REG.2015/1188 Item Symbol Value Unit Item Unit Heat output Type of heat input for electric storage local heaters only Measured seasonal space Manual heat charge control with heating energy efficiency integrated thermostat Nominal Manual heat charge control with heat output...
-
Page 4: Safety Rules
Room temperature control with adaptive start control Room temperature control with working time limitation Room temperature control with black bulb sensor SAFETY RULES Make sure that you read, understand and comply with the following. WARNING: THIS PRODUCT IS ONLY SUITABLE FOR WELL INSULATED SPACES OR OCCASIONAL USE. - Page 5 • Do not abuse the electrical cable. Never use the cable for pulling or unplugging the heater. • Keep the cable away from sources of heat, oil, sharp edges or moving parts. Damaged or tangled cables increase the risk of electric shock. •...
-
Page 6: Safety Symbols
THE CLARKE SERVICE DEPARTMENT. • Check that the heater is in good working order. Take immediate action to have any damaged parts repaired or replaced by the Clarke service department. • Do not allow the heating elements to become covered with dust which could become a fire hazard. -
Page 7: Electrical Connections
ELECTRICAL CONNECTIONS WARNING: READ THESE ELECTRICAL SAFETY INSTRUCTIONS THOROUGHLY BEFORE CONNECTING THE HEATER TO THE MAINS SUPPLY. Connect the mains lead to a standard, 230 Volt (50Hz) electrical supply through an approved 13 amp BS 1363 plug, or a suitably fused isolator switch. If the plug has to be changed because it is not suitable for your socket, or because of damage, it must be removed and a replacement fitted, following the wiring instructions shown below. -
Page 8: Operation
In effect, this means that this product must not be discarded with general household waste. It must be discarded according to the laws governing Waste Electrical and Electronic Equipment (WEEE) at a recognised disposal facility. OPERATION WARNING: DO NOT USE THIS HEATER IN SMALL ROOMS IF OCCUPIED BY PERSONS NOT CAPABLE OF LEAVING THE ROOM ON THEIR OWN, UNLESS CONSTANT SUPERVISION IS PROVIDED. -
Page 9: Safety Systems
SAFETY SYSTEMS The Devil 2800 has a thermal cut out to prevent the unit from overheating. If the temperature of the front grille gets too high the thermal cutout will turn off the heating elements. When the fan has cooled the unit sufficiently, normal operation will resume. -
Page 10: Fault Finding
Fuse blown or Replace if necessary and investigate although circuit breaker cause. If fuse blows repeatedly, consult plugged in trips. your Clarke dealer. with the No power at Insert the plug in a functioning socket. switch and socket outlet thermostat switched on. -
Page 11: Parts List And Diagram
PARTS LIST & DIAGRAM Front Cover Waterproof Ring Heating Element Rear Cover Thermal Baffle Knob Thermostat Cover Cable Fastener Middle Panel Power Cable Thermostat Re-set Cable Fastener Bracket Rear Grille Tip-over Switch / Bracket Motor Top Cover Handle Bottom Cover Adjustable Thermostat Rear Foot Switch...
Need help?
Do you have a question about the DEVIL 2800 and is the answer not in the manual?
Questions and answers