Subscribe to Our Youtube Channel
Related Manuals for Clarke DEVIL 2850
Summary of Contents for Clarke DEVIL 2850
- Page 1 Only suitable for well insulated areas and not designed to be the primary heat source 2.8KW DEVIL 2850 HEATER MODEL NO: DEVIL 2850 PART NO: 6925801 OPERATION & MAINTENANCE INSTRUCTIONS ORIGINAL INSTRUCTIONS GC0221 - REV 1...
-
Page 2: Specifications
INTRODUCTION Thank you for purchasing this CLARKE product. Before attempting to use this product, read this manual carefully. In doing so you guarantee the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service... - Page 3 THE FOLLOWING TABLE ADDRESSES THE INFORMATION REQUIREMENTS OF REG.2015/1188 Item Symbol Value Unit Item Unit Heat output Type of heat input for electric storage local heaters only Measured seasonal space Manual heat charge control with heating energy efficiency integrated thermostat Nominal heat Manual heat charge control with room output...
-
Page 4: Safety Rules
SAFETY RULES Make sure that you read, understand and comply with the following rules.. WARNING: THIS PRODUCT IS ONLY SUITABLE FOR WELL INSULATED AREAS AND IS NOT DESIGNED TO BE THE PRIMARY HEAT SOURCE. SAFE WORKING PRACTICES • DO NOT operate the heater when you are tired or under the influence of alcohol, drugs or intoxicating medication. - Page 5 POSITIONING WARNING: DO NOT USE THE HEATER NEAR FLAMMABLE MATERIAL, LIQUIDS, SOLIDS, GASSES OR COMPRESSED GAS CYLINDERS ETC. • This heater is designed for indoor use only. • DO NOT place the heater close to any water-filled area or wet surface. •...
-
Page 6: Maintenance
MAINTENANCE • Check that the heater is in good working order. Take immediate action to have any damaged parts repaired or replaced by the CLARKE service department. • DO NOT allow the heating elements to become covered with dust which could become a fire hazard. If used in a dusty workplace it should be cleaned as described under Maintenance on page 10. -
Page 7: Electrical Connections
ELECTRICAL CONNECTIONS WARNING: READ THESE ELECTRICAL SAFETY INSTRUCTIONS THOROUGHLY BEFORE CONNECTING THE HEATER TO THE MAINS SUPPLY. Connect the mains lead to a standard, 230 Volt (50Hz) electrical supply through an approved 13 amp BS 1363 plug, or a suitably fused isolator switch. If the plug has to be changed because it is not suitable for your socket, or because of damage, it must be removed and a replacement fitted, following the wiring instructions shown below. -
Page 8: Operation
OPERATION WARNING: DO NOT USE THIS HEATER IN SMALL ROOMS IF OCCUPIED BY PERSONS NOT CAPABLE OF LEAVING THE ROOM ON THEIR OWN, UNLESS CONSTANT SUPERVISION IS PROVIDED. CAUTION: SOME PARTS OF THIS PRODUCT CAN BECOME VERY HOT AND CAUSE BURNS. PARTICULAR ATTENTION HAS TO BE GIVEN WHERE CHILDREN AND VULNERABLE PEOPLE ARE PRESENT. -
Page 9: Safety Systems
8. When not in use, disconnect the heater from the mains supply. SAFETY SYSTEMS The Devil 2850 has a thermal cut out to prevent the unit from overheating. If the temperature of the front grille gets too high the thermal cutout will turn off the heating elements. -
Page 10: Environmental Recycling Policy
1. Clean the heater with a soft damp cloth, Do not use solvents or abrasives. 2. No other maintenance is required, should you discover any problem with the heater, return it to the CLARKE service department for repair. 3. Store the heater in a dry, ventilated place. -
Page 11: Declarations Of Conformity
DECLARATIONS OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
Need help?
Do you have a question about the DEVIL 2850 and is the answer not in the manual?
Questions and answers