Related Manuals for Clarke DEVIL 3003
Summary of Contents for Clarke DEVIL 3003
- Page 1 Only suitable for well insulated areas and not designed to be the primary heat source 2.8KW ELECTRIC HEATER(110V) MODEL NO: DEVIL 3003 PART NO: 6925125 OPERATION & MAINTENANCE INSTRUCTIONS ORIGINAL INSTRUCTIONS GC0621 rev 2...
-
Page 2: Specifications
INTRODUCTION Thank you for purchasing this CLARKE product. Before attempting to use this product, read this manual carefully. In doing so you guarantee the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service... - Page 3 THIS TABLE ADDRESSES THE INFORMATION REQUIREMENTS OF REG.2015/ Item Symbol Value Unit Item Unit Heat output Type of heat input for electric storage local heaters only Measured seasonal space Manual heat charge control with heating energy efficiency integrated thermostat Nominal heat Manual heat charge control with room output and/or outdoor temperature feedback...
-
Page 4: Safety Rules
SAFETY RULES Make sure that you read, understand and comply with the following. WARNING: THIS PRODUCT IS ONLY SUITABLE FOR WELL INSULATED AREAS AND IS NOT DESIGNED TO BE THE PRIMARY HEAT SOURCE. SAFE WORKING PRACTICES • DO NOT operate the heater when you are tired or under the influence of alcohol, drugs or intoxicating medication. - Page 5 POSITIONING WARNING: DO NOT USE THE HEATER NEAR FLAMMABLE MATERIAL, LIQUIDS, SOLIDS, GASSES OR COMPRESSED GAS CYLINDERS ETC. • This heater is designed for indoor use only. • DO NOT place the heater close to any water-filled area or wet surface. •...
-
Page 6: Safety Symbols
THE CLARKE SERVICE DEPARTMENT. • Check that the heater is in good working order. Take immediate action to have any damaged parts repaired or replaced by the Clarke service department. • DO NOT allow the heating elements to become covered with dust which could become a fire hazard. -
Page 7: Electrical Connections
ELECTRICAL CONNECTIONS WARNING: READ THESE ELECTRICAL SAFETY INSTRUCTIONS THOROUGHLY BEFORE CONNECTING THE HEATER TO THE POWER SUPPLY. This heater MUST be connected to a 110 Volt, 1 phase 50Hz supply through a suitably fused isolator switch. ON NO ACCOUNT MUST A 230V, 13AMP (BS1363) PLUG BE USED. -
Page 8: Operation
OPERATION WARNING: DO NOT USE THIS HEATER IN SMALL ROOMS IF OCCUPIED BY PERSONS NOT CAPABLE OF LEAVING THE ROOM ON THEIR OWN UNLESS CONSTANT SUPERVISION IS PROVIDED. CAUTION: SOME PARTS OF THIS PRODUCT CAN BECOME VERY HOT AND CAUSE BURNS. PARTICULAR ATTENTION HAS TO BE GIVEN WHERE CHILDREN AND VULNERABLE PEOPLE ARE PRESENT. -
Page 9: Safety Systems
SAFETY SYSTEMS The Devil 3003 has a thermal cut out to prevent the unit from overheating. If the temperature of the front grille gets too high the thermal cutout will turn off the heating elements. When the fan has cooled the unit sufficiently, normal operation will resume. -
Page 10: Fault Finding
Fuse blown or Replace if necessary and investigate although circuit breaker has cause. If fuse blows repeatedly, consult plugged in tripped. your Clarke dealer. with the No power at Insert the plug in a functioning socket. selector socket outlet. switch and thermostat switched on. -
Page 11: Declarations Of Conformity
DECLARATIONS OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
Need help?
Do you have a question about the DEVIL 3003 and is the answer not in the manual?
Questions and answers