Clarke Devil 330 Operating & Maintenance Instructions
Clarke Devil 330 Operating & Maintenance Instructions

Clarke Devil 330 Operating & Maintenance Instructions

Ceramic space heaters

Advertisement

Quick Links

DEVIL CERAMIC SPACE
HEATERS
Devil 330
Part Nos: 6920264 (110V) & 6920265 (230V)
OPERATING & MAINTENANCE
INSTRUCTIONS
GC0310

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Devil 330 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Clarke Devil 330

  • Page 1 DEVIL CERAMIC SPACE HEATERS Devil 330 Part Nos: 6920264 (110V) & 6920265 (230V) OPERATING & MAINTENANCE INSTRUCTIONS GC0310...
  • Page 2: Environmental Protection

    INTRODUCTION Thank you for purchasing this CLARKE Ceramic Space Heater. Please read this manual thoroughly and follow the instructions carefully. Before attempting to use the heater, thoroughly familiarise yourself with the heater & its operation. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to the heater giving you long and satisfactory service.
  • Page 3: General Safety Rules

    GENERAL SAFETY RULES WORK AREA 1. These heaters are for INDOOR USE ONLY. 2. Do not expose the heater or power cable to rain or wet conditions. Any water entering the heater will increase the risk of electric shock. DO NOT use this heater in a bathroom, shower room or any other wet environment.
  • Page 4: Service And Repairs

    ELECTRICAL CONNECTIONS 230V HEATER The 230v model (Clarke part no 6920265) is provided with a 13 amp BS 1363 plug, fitted with a 13amp fuse and MUST be connected to a standard, 230 Volt (50Hz) electrical supply, preferably through a suitably fused isolator switch.
  • Page 5 Residual Current Device (RCD). 110V HEATER The 110v model (Clarke part no 6920264) MUST be connected to a 110 Volt, 1 phase 50Hz supply through a suitably fused isolator switch. On no account must a 230V, 13amp (BS1363) plug be used.
  • Page 6: Unpacking And Assembly

    UNPACKING AND ASSEMBLY Before assembling, please check contents against the following list and advise your dealer immediately if any parts are missing. 1 x Heater 2 x Support Legs 4 x Screws 1. Attach the side legs to the heater using the screws provided.
  • Page 7: Cleaning And Maintenance

    DO NOT use abrasive cleaners. Take care that no moisture enters the heater. • Refer to your CLARKE dealer if internal maintenance is required. • When storing the heater, allow it to cool down, then place it in its packing box for storage in a dry, ventilated place.
  • Page 8: Fault Finding

    FAULT FINDING l l u & , y l l n i y l l . t i...
  • Page 9: Component Parts

    COMPONENT PARTS...
  • Page 10: Technical Specification

    Please note that the details and specifications contained herein, are correct at the time of going to print. However, CLARKE International reserve the right to change specifications at any time without prior notice. A selection of suitable extension leads & plugs is available from your nearest CLARKE dealer, for further information, contact your nearest dealer, or telephone CLARKE International Sales department on 01992 565300.
  • Page 11: Declaration Of Conformity

    DECLARATION OF CONFORMITY...

This manual is also suitable for:

Devil 330 6920264Devil 330 6920265

Table of Contents