Table of Contents
Advertisement
German
degrees
(°dH)
4 - 10
< 4
1) Factory position.
2) Do not use salt at this level.
Manual adjustment
1
Electronic adjustment
1. Press the on/off button to activate the appliance.
2. Make sure that the appliance is in setting mode. Refer
to 'SETTING AND STARTING A PROGRAMME'.
3. Press and hold function buttons (B) and (C) at the
same time until the indicators above function buttons
(A), (B) and (C) flash.
4. Press function button (A).
• The indicators above function buttons (B) and (C)
go off.
• The indicator above function button (A) continues
to flash.
• The display shows the setting of the water soften-
er. Example:
5. Press function button (A) again and again to change
the setting.
6. Deactivate the appliance to confirm.
Filling the salt container
Caution! Only use dishwasher salt. Other products
can cause damage to the appliance.
www.zanussi.com
Water hardness
French
degrees
(°fH)
7 - 18
< 7
2
Turn the water hardness
dial to the position 1 or 2.
= level 5.
mmol/l
Clarke
degrees
0.7 - 1.8
5 - 12
< 0.7
< 5
Water and salt can come out from the salt container when
you fill it. Risk of corrosion. To prevent it, after you fill the
salt container, start a programme.
1
3
Put 1 litre of water in the
salt container (only for the
first time).
5
Water softener
adjustment
Manual
Electronic
1
2
2)
2)
1
1
2
4
6
7
Advertisement
Table of Contents
