Technical Information - Zanussi ZDF 4013 User Manual

Problem
Dry water drop stains on
glasses and dishes.
The dishes are wet.
The dishes are wet and matt.
Activating the rinse aid dispenser with the multitab
function activated
1. Press the on/off button to activate the appliance.
2. Make sure that the appliance is in setting mode. Refer
to 'SETTING AND STARTING A PROGRAMME'.
3. Press and hold function buttons (B) and (C) at the
same time until the indicators above function buttons
(A), (B) and (C) flash.
4. Press function button (B) .
• The indicators above function buttons (A) and (C)
go off.
• The indicator above function button (B) continues
to flash.

Technical information

Dimensions
Electrical connection
Water supply pressure
1)
Water supply
www.zanussi.com
Possible cause
The quantity of detergent was too much.
The released quantity of rinse aid was
not sufficient .
The quality of the detergent can be the
cause.
The programme had no drying phase.
The rinse aid dispenser is empty.
The quality of the rinse aid can be the
cause.
The quality of the combi detergent tab-
lets can be the cause.
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
Cold water or hot water
Make sure that you add the correct quan-
tity of detergent in the dispenser before
you start a programme.
Increase the released quantity of rinse aid.
Try a different brand of detergent.
Set a programme with the drying phase.
Make sure that there is rinse aid in the
rinse aid dispenser.
Try a different brand of rinse aid.
• Try a different brand of combi deter-
gent tablets.
• Activate the rinse aid dispenser and
use the rinse aid together with the
combi detergent tablets.
• The display shows the setting of the rinse aid dis-
penser.
5. Press function button (B) to change the setting.
6. Deactivate the appliance to confirm.
7. Adjust the released quantity of rinse aid.
8. Fill the rinse aid dispenser.
2)
Possible solution
Off
On
600 / 850 / 610
220-240 V
50 Hz
(0.5 / 0.05 ) / (8 / 0.8 )
max. 60 °C
13