Sampling In Dribble Mode - NCI 7050 User Manual

Sampling in Dribble Mode

scale uses this to determine the count of pieces
placed on the scale. The piece weight is kept in
memory until a new sample is taken.
You can sample using the bulk or dribble
modes. F F F F F actory default is dribble mode actory default is dribble mode actory default is dribble mode
actory default is dribble mode actory default is dribble mode.
This can be changed to bulk mode in
configuration.
In dribble mode the scale prompts you to place
the sample pieces on the platform one at a
time, or all at one time, and when you are done,
ENTER ENTER
press the ENTER ENTER ENTER key. The scale calculates the
piece weight and puts the display into the count
mode. This allows you to count out pieces onto
the platform.
In bulk mode you are prompted to place a
specific number of pieces on the scale all at
one time. After motion ceases the scale
automatically calculates the piece weight and
goes into the count mode. This means you must
have the counted pieces or sample ready to
place on the scale all at once.
Follow these steps to perform a sampling
operation using the dribble mode:
1. Press the SAMPLE softkey. . .
The scale zeroes itself and the display
prompts: Load 10 samples or key
in a sample size larger than 10, in a sample size larger than 10,
in a sample size larger than 10, in a sample size larger than 10, in a sample size larger than 10,
press ENTER. Sample Size = 10. press ENTER. Sample Size = 10. press ENTER. Sample Size = 10.
press ENTER. Sample Size = 10. press ENTER. Sample Size = 10.
Ten is the default sample size.
Minimum sample size can be changed
in configuration.
Load 10 samples or key Load 10 samples or key
Load 10 samples or key Load 10 samples or key
10