Dryer Description; The Features; Control Panel - Hotpoint AQUALTIS AAQCF 81 U Instruction Booklet

Dryer Description

To open door
Pull on handle
Heat Pump Filter
Unit
(cover open)

Control Panel

On/Off Button & Light
Programme Knob
The On/Off button/ light
button is pressed the dryer is turned off. The light signals that
your dryer is in use or ready to select a programme.
The Programmes knob sets the programme: rotate until the
indicator is pointing to the programme you want to select (see
Start and Programmes).
The Option buttons/ lights select available options for your
selected programme. The lights indicate that the option has
been selected (see Start and Programmes).
The Display Panel has three sections: Sensor Dry = Drying
level, Timed dry = Drying time and Time to End / Delay start
each with a corresponding selection button (see The Display).
START/PAUSE button with indicator light
green indicator light flashes slowly, press the button to
start the programme. When the cycle has started, the
indicator light is illuminated in a fixed manner. To pause
the programme, press the button again; the indicator light
will turn orange and begin to flash again. To restart the
programme from the point at which it was interrupted, press
the button again (see Start and Programmes).
The Programme Progress Lights indicate each state of the
programme by turning on as appropriate.(see Start and
Programmes).
Indicator Display Panel
Option Buttons and Lights
, if the dryer is running and this
: when the

The Features

Rating
Plate
Water
container
Filter
Ajustable feet
(to level dryer)
ECO Light
Start/Pause Button
& Light
Clean Heat
Filter
Pump
The Empty Water indicator
container should be emptied. The light will take a few seconds
to go out after replacing the empty water container; the dryer
must be running for this to happen (see The Controls).
Note: if the water bottle is full the display shows
the indicator flashes, the heat is turned off and your clothes
will not dry.
The Empty Water Clean Filter Light
before every programme, that its essential to clean the filter and
empty the water container every time the dryer is used (see
Maintenance and Care).
The Clean Heat Pump Filter Light
essential to clean this filter at regular intervals (see Maintenance
and Care).
The Child Lock button/light
selecting your programme and any options. This prevents the
programme settings from being changed.
When the light is lit the other buttons and programme knob are
disabled. Hold the button to cancel and the light will go out.
ECO Light - this light is illuminated as you select options that
use less energy (see the controls).
Model
& Serial
Numbers
Air Intake
Grille
Heat Pump Filter Unit cover
handle
(Pull here to open)
Child Lock
Button & Light
Programme
Empty
Water Clean Progress Light
Filter Light
"H2O"
signals that the water
"H2O"
and
gives a reminder
gives a reminder, that its
Press and hold this button after
GB
5