Table of Contents
Advertisement
Control and Use
Control
Temperature Regulator for
Refrigerator:
«A» Fig.3
Allows to adjust the temperature inside the refrigerator
according to use and external conditions.
• Pos. 1 = Minimum cold.
• Pos. 6 = Maximum cold.
• Pos. 0 = Motor disconnected.
Interior light:
Fig.3
Comes on when opening the door of the refrigerating com-
partment.
When changing the light bulb, first remove the protective
cover «X» after pull out the screw "Y" (see point A1, «IF
SOMETHING DOES NOT WORK»).
Dinamic Refrigeration (DAC):
Its use is particularly suitable:
• In hot weather (ambient temperature of over 25º) and
when a lot of foodstuffs have just been stored.
• In damp atmospheres (if a lot of frost forms on the back
wall of the refrigerator cabinet or droplets of water appear
on the shelves).
To operate, press the switch.
The DAC Dynamic Refrigeration system improves the per-
formance of the fridge compartment as can be seen by:
· Faster cooling
· A more uniform temperature distribution
NOTE: When the DAC is operating on, cold production is
heightened, so the refrigerator temperature control must be
set to
to avoid excessive cold.
Inner Door Compartments Position
The door compartments can be pulled up and removed (Fig.
5), and inserted at other positions as needed.
Shelves Position
Your appliance is equipped with a special shelve. The four
positions (see possible positions in Fig. 6) that you can
place this shelve, allow you the different food storage. The
drawer can be only fixed in the upper position on Fig. 6.1.If
you change the position of the special shelve, please, take
care to put the rubber plugs into the front of the shelve. You
can disassemble and assemble the plugs easily.
The remain storage shelves can be adjusted to various
heights.
14
Fig.4
Y
X
PR187
Fig. 3
Fig. 4
Fig. 5
6.1
6.2
Fig. 6
6.3
6.4
Advertisement
Table of Contents
