Changing The Opening Directions Of The Doors - Zanussi ZD25/6AT User Manual

Changing the opening direction of doors
If you wish to change the opening side of the doors
proceed as follows:
1... Take off the plinth (A) pressed onto cabinet. Take
out the lid (B) and put it into the opposite hole.
2... Remove the lower hinge (C) taking care for the
lower door not to fall off. Be carefull not to lose
the plastic washer.
3... Lift the lower door off the central hinge (D).
4... Remove the central hinge (D) taking care for the
upper door not to fall off and not to lose the plas-
tic washer.
5... Take the upper door off the upper hinge (E). Be
carefull not to lose the plastic washer.
6... Unscrew the plastic plugs located on the opposi-
te side of the central hinge and introduce them in
the holes occupied before by the hinge.
7... Unscrew the axle of the upper hing and screw it
into the hinge on the opposite side.
8... Place upper door.
9... Put the central hinge (D) in the opposite side from
original position. Leave the hinge loose.
10...Place the lower door next to the lower hinge (C)
in the opposite side from original and fix all the
hinges. Before it, using a 10mm spanner, uns-
crew the hinge pin and reassemble it on the
opposite side.
11...Dismantle the vertical handles and assemble
them in the opposite side. Cover the holes with
the plastic lids that were situated where the hand-
les are presently.
PR220
12...Replace the plinth (A) well fixed.
m m
Once finished make sure that all joints close
perfectly well all around the door and chek that
the internal light turns of when the fridge door
closes.
13