Table of Contents
Advertisement
Installation
Positioning
• Place the refrigerator away from direct sunlight
and heat sources.
• Maintain recommended ventilation - see Fig. 1.
• Make sure the refrigerator is accurately levelled
turning the adjustable feet in order to avoid vibra-
tions and noises, Fig. 2.
• This is a built in design to be aligned with other
furniture
• The appliance must be located in places of maxi-
mum temperature as follows:
SN
N
ST
T
If the temperature are higher than these both
above mentioned, the functions of appliance coudl
result reduced.
• With the freezer door wide-open, assemble the
socle provided inside the appliance, following the
instructions stuck on it.
12
Fig. 1
Fig. 2
+10 to +32ºC
+16 to +32ºC
+18 to +38ºC
+18 to +43ºC
Cleaning the interior
• Do not use alcohol or any cleanig product contai-
ning alcohol because it can damage the cabinet.
• Before using the appliance for the first time wash
the interior whith luke warm water and some neu-
tral soap so as to remove the typical smell of a
brand-new product arid then dry thoroughly.
• Do not use detergents or abrasive powders as
these will damage the finish.
• Remove security used for transportation.
Electrical connection
m Before plugging the appliance make sure that the
voltage and frequency shown on the «Technical
Features» correspond to your home supply.
It is essential that the appliance be efficiently
earthed.
m For this purpose the supply cable plug incorpora-
tes a special earth contact. If the sockets of your
domestic wiring system are not grounded, have
the appliance connected to a separate ground wire
in accordance with existing safety regulations.
«THE MANUFACTURER DECLINES TO ACCEPT
ANY LIABILITY IF THIS SAFETY RULE IS NOT
OBSERVED».
Starting – up
• Plug the appliance into the mains.
• Make sure the inner light turns on when opening
the door.
• Turn to intermediate position the knobs of the
«temperature regulator» «A» (See Control And
Use paragraph).
Advertisement
Table of Contents
