Installation; Gas Connection - Zanussi ZGG 649 Instruction Booklet

Installation

IMPORTANT
This appliance must be installed by
qualified personnel.
The manufacturer will not accept
liability, should the above instructions
or any of the other safety instructions
incorporated in this book be ignored.

Gas Connection

On the end of the shaft (A) , which includes the
GJ 1/2" threaded elbow, an adjustable joint is
fixed so that the washer (B) is fitted between
the components as shown in the diagram.
A drop of paint at both edges of the "L" joint (C)
will evidence that the good seal of the
connection has been tested in the factory.
Before connecting the gas supply pipe to the
joint (C), the installer will ensure that the paint
drop is unbroken and the "L" connector has not
been moved by the vibrations during handling
and transportation.
When the final connection has been made, it is
essential that a thorough leak test is carried out
on the hob and installation.
Ensure that the main connection pipe does not
exert any strain on the hob.
Cut Out Size
The dimensions of the cut-out are given in the
diagram.
FO 1010
A) End of shaft with nut
B) Washer
C) Adjustable joint
Rectangular cut-out size for hob
580
550
FO 2106
7
510
470