Brookstone BodyForm User Manual page 12

14. Attach the MONITOR to the MONITOR ARM with its included screws, insert the
batteries (see page 12 for steps), and plug in the monitor wire.
Monitor Wire
15. Use the LOCKING HANDLE to position the SEAT BAR CONNECTOR for
either storage with the SEAT RAIL up (as shown below) or for use
with the SEAT RAIL down.
16 . Use the HEIGHT ADJUSTERS on the REAR SEAT SUPPORT to level the rower
during use.
11
Note: Two screws are
pre-installed on the
back of the monitor.
Remove the screws
prior to assembly.