Table of Contents
Advertisement
3.7.2. Modifying the current programme
Before modifying the current programme, you must put the
washing machine to pause by pressing on the «Start/Pau-
se» pushbutton. If it is impossible to make the modification,
the corresponding light flashes for few seconds. If you de-
cide to change the programme in any case, you will need
to cancel the current programme (see below).
3.7.3. Cancelling the programme
If you want to cancel a programme, turn the programme
selector knob to the «off» position of the programme
selector.
You can then select a new programme after cancelling the
previous one.
3.8. End of program
The washing machine stops automatically. The «cycle
end» light goes on. The opening of the lid is only possible
2 minutes after the washing machine stops.
If you choose the rinse hold pushbutton, the rinse hold
light* illuminates to inform you that water has to be drained
before you can open the cover. To terminate the cycle, you
can then spin the washing by choosing the spinning
program or drain it by choosing the drain program.
Turn the program selector knob to the «Off» position.
Take out the washing.
Pull out the power supply plug and close the water supply
tap.
Note: we recommend that you should leave the cover and
the drum open after use to air the washing drum.
*according to the model
6
Hide quick links:
Advertisement
Table of Contents
