ALLEN & HEATH RPS11 User Manual

ALLEN & HEATH RPS11 User Manual

Rack mount power supply

Advertisement

RPS11
Rack Mount Power Supply

USER GUIDE

Publication AP2725

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RPS11 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for ALLEN & HEATH RPS11

  • Page 1: User Guide

    RPS11 Rack Mount Power Supply USER GUIDE Publication AP2725...
  • Page 2: Limited One-Year Warranty

    Warranty LIMITED ONE YEAR WARRANTY This product has been manufactured in the UK by ALLEN & HEATH and is warranted to be free from defects in materials or workmanship for a period of one year from the date of purchase by the original owner. To ensure the high level of performance and reliability for which this equipment has been designed and manufactured please read the User Guide before use.
  • Page 3: Precautions And Safety Instructions

    The RPS11 is supplied in a specially designed cardboard box. If it is necessary to move the unit any distance after installation, it is recommended that this carton is used to protect it. Be sure to disconnect all cabling before moving. If the RPS11 is to be moved regularly (e.g.
  • Page 4: Rack Mounting

    Finally, some consideration should be given to the earthing arrangement of the system, at the centre of which is the console and the RPS11. The console chassis is earthed, to the mains earth, via the power supply. When rack-mounting the RPS11 care should be taken to avoid any possible “ground loops”...
  • Page 5: Replacing Mains Fuse

    SPECIAL ATTENTION SHOULD BE GIVEN TO THE FOLLOWING INFORMATION The RPS11 is capable of operating over a wide range of AC mains input voltages by means of a mains voltage selector. It is important to check that the RPS11 has the correct voltage setting as marked on the rear panel of the power supply. Confirm that the voltage setting matches the local AC mains supply in your area.
  • Page 6: Technical Specification

    The AC mains fuse is located on the rear of the RPS11 unit next to the AC mains connector. In the event of a mains surge or under-rated fuse value, the mains input fuse will rupture. Switch off the power supply and remove the mains lead plug from the “AC MAINS IN”...
  • Page 7 DISCONNECTING THE MAINS SUPPLY LEAD FROM THE POWER SUPPLY UNIT The RPS11 power supply unit requires no internal maintenance or regular servicing. If the RPS11 requires servicing or repair then refer to the service manual for the power supply or contact your Allen & Heath dealer.

Table of Contents

Save PDF