Installation Install the power supply unit in accordance with the instructions printed in this User Guide. Do not connect the output of power supply unit to any other equipment other than that specified by Allen & Heath. RPS15 User Guide...
Page 4
Full extension of the cable can stress the mixing console and power supply unit connectors and may result in undesired performance. Ensure that the power cable is located such that it cannot be stood on or tripped over. RPS15 User Guide...
Page 5
Introduction This user guide presents a quick reference to the RPS15. We recommend that you read this fully before starting. Included is information on installing, connecting and operating the power supply unit along with panel drawings and technical specification. Whilst we believe the information in this guide to be reliable we do not assume responsibility for inaccuracies.
Rack mounting The RPS15 is designed as a 19 inch rack mount unit and will occupy 2U (3.5 inches) of rack space. The fast feet may need to be removed before rack mounting. Retain feet for future use.
Replacing the mains fuse The AC mains fuse is located on the rear of the RPS15 unit next to the AC mains connector. In the event of a mains surge or under-rated fuse value, the fuse will rupture. Switch off the power supply and remove the mains lead plug from the “MAINS INPUT”...
Need help?
Do you have a question about the RPS15 and is the answer not in the manual?
Questions and answers