Pro-Ject Audio Systems Pro-Ject DEBUT III PHONO SB Instructions For Use Manual page 6

Technical specifications PRO-JECT DEBUT III/PHONO SB
* Electronic speed change
Speed variance
Wow and flutter
Signal to noise
Downforce range
Effective tonearm length
Overhang
Power consumption
Outboard power supply
Dimensions (W x H x D)
Weight
Moving magnet phono pre-amplifier
Gain
Output voltage typically
Input impedance
Noise floor
RIAA-equalisation curve accuracy
Potential incorrect use and fault conditions
PRO-JECT turntables are manufactured to the highest standards and undergo strict quality controls before
leaving the factory. Faults that may possibly occur are not necessarily due to material or production faults but
can sometimes be caused by incorrect use or unfortunate circumstances. Therefore the following list of common
fault symptoms is included.
The platter doesn't turn although the unit is switched on:
The unit is not connected to the mains power supply. No mains at the socket.
Drive belt is not fitted or has slipped off.
No signal through one or other channel or both channels:
No signal contact from the cartridge to the internal tonearm wiring or from that to
the arm lead or between that and the amplifier. This could be due to a faulty plug,
broken wire or solder joint or simply loose plug/socket connection.
Wrong input selected at amplifier.
Amplifier not switched on.
Amplifier or speakers defective or muted.
No connection to the loudspeakers.
Distorted or inconsistent sound from one or both channels:
Needle or cantilever damaged.
Wrong r.p.m., drive belt overstretched or dirty, platter bearing without oil, dirty or damaged.
Service
Should you encounter a problem which you are not able to alleviate or identify despite the above information,
please contact your dealer for further advice. Only when the problem cannot be resolved there should the
unit be sent to the responsible distributor in your country.
Guarantee repairs will only be effected if the unit is returned correctly packaged. For this reason we recommend
keeping the original packaging. Never return a record player without making sure that is it safely
disassembled and correctly packaged in the original packaging according to the diagrams on the last page of
this user guide. Please remove these parts and pack them separately: lid (10), counterweight (6), anti-skating
weight (16) platter (5), cartridge and belt (3). Fit the cartridge protection cap. Insert the transport screws for
the motor (1) and the transport lock for the tonearm (18) prior to carefully packaging the record player.
6
© Audio Trade GmbH · Pro-Ject Debut III / Phono SB / Ortofon OM 5E · Revision 1.3.08/1.5.08
* 33,33/* 45,11 and 78 r.p.m.
±0,8 %
±0,12 %
-65dB
10-30mN
8,6 " ( 218,5mm)
18,5mm
6,5W
16V/500mA AC, suitable for your country's mains supply
415 x 118 x 320mm, dust cover open 415 x 365 x 405mm
6kg
32dB
160mV/1kHz at 4mV/1kHz input
47kohms/100pF
-88dB
20Hz-20kHz / max. 0,5dB