Changing Replay Speed; Pitch Control; Maintenance And Cleaning; Useful Tips - Pro-Ject Audio Systems Pro-Ject RPM 9.1 SuperPack 1 Instructions For Use Manual

Dj equipment

Table of Contents

Changing replay speed

The belt must be on the smaller (50Hz models) larger (60Hz models) diameter part of the motor pulley.

Press the speed change button 33/45 to switch between 33 and 45 r.p.m.. The selected speed will be

displayed digitally. To play at 45 r.p.m. please always start the turntable at 33 r.p.m. and then switch to the

higher speed when it has attained full speed.

Speed Box SE

45.0

33/45

Adjust

StBy

Adjust

Repeatedly pressing the + or - buttons (Adjust) increases or decreases the replay speed in twenty steps of

0,1 r.p.m. respectively. The adjusted speed is displayed digitally.

Stand By

Press and hold the speed change button 33/45 to put the Speed Box SE into stand by. Pressing the button

33/45 will switch on the Speed Box SE from stand by.

Fitting the optional lid

Fit the lid carefully on to the record player from above.

Your record player requires little or no regular maintenance. Remove dust with a slightly moistened antistatic

cloth. Never use a dry cloth because this will create static electricity which attract more dust! Antistatic

cleaning fluids are available at specialist stores but must be applied sparingly to avoid damage to rubber

parts. It is recommended to fit the needle cover before cleaning or maintenance is carried out to avoid damage.

If the player is not used over a long period of time the drive belt can be removed to prevent unequal stretching.

Always disconnect the record player from the mains power supply as a precaution before maintenance!

The lid (optional) is not only a dust cover but also a resonant structure likely to be excited by, and to pass into

the plinth, the acoustic energy emanating from your loudspeakers during replay. It is therefore recommended

that the lid be removed for optimum sound quality.

The record player should be positioned on a low-resonance surface such as wood or multiple layer ply board

to avoid structural vibrations disturbing replay.

Table of Contents