Select The Delay Time; Select The Temperature; Start The Programme; Select The Desired Options - Zanussi FE 1205 Instruction Booklet

132990110•gb 17-11-2003 9:42

6. Select the temperature

Press the TEMPERATURE
select a temperature value different from the one
proposed by the washing machine.
The relevant light will light up.
7. Select the spin speed
(RINSE HOLD) option
Press the SPIN SPEED button repeatedly, in order
to select the desired spin speed or the RINSE HOLD
option. The relevant light will light up.
If you select the RINSE HOLD option, the machine
will stop at the end of the programme with the water
still in the tub.

8. Select the desired options

Depress the relevant buttons to select the required
options.
Pagina 16
button if you wish to
or
16

9. Select the DELAY TIME

Before you start the programme, if you wish the
starting to be delayed, press the DELAY button
repeatedly, or keep it pressed, to select the desired
delay. The selected delay time value (up to 23 hours)
will appear on the display for 3 seconds, then the
duration of the programme will appear again.
DELAY

10. Start the programme

Press the START/PAUSE button. The relevant light
will stop flashing, and only the light relevant to the
phase that is in progress will remain lit.
If you have chosen a delayed start, the washing
machine will begin the countdown.
The display will show the duration of the programme
or the selected delay.
11. How to change a programme
during its cycle
Before you make any change, you must pause the
washing machine by pressing the START/PAUSE button.
It is possible to change any phase before the
programme carries it out.
Changing the type of fabric or temperature is
possible, obviously, only during the washing phase.
If it is necessary to drain the water in order to change
the programme in progress, proceed as follows:
• PAUSE the machine by pressing the
START/PAUSE button;
• press the SKIP/RESET button repeatedly, until
only the DRAIN light remains lit;
• press the START/PAUSE button again.
When the water has been drained, the display shows a
blinking zero. You may now select a new programme
and press the START/PAUSE button to start it.