Filling The Detergent And Additives; Select The Delay Start - Zanussi ZWC1301 User Manual

FILLING THE DETERGENT AND ADDITIVES

When you set a programme with prewash, put the detergent for prewashing phase directly
into the drum.
Always follow the instructions that you find on the packaging of the detergent products, but
we recommend that you do not exceed the maximum indicated level (
however guarantee the best washing results.
After a washing cycle, if necessary, remove any detergent residue from the detergent
dispenser.
SELECT THE REQUIRED PROGRAMME BY
MEANS OF THE PROGRAMME SELECTOR
DIAL
Turn the programme selector dial to the required
programme. The selector can be turned either
clockwise or anticlockwise.
The green light of button
to flash.
The pilot lights corresponding to all phases
composing the selected programme are on.
On position the programme is reset and the
machine is switched OFF.
At the end of the programme the selector dial must
be turned to position
If you turn the programme selector dial
to another programme when the
machine is working, the lights in the
programme progress display will start
to flash to indicate a wrong selection.
The machine will not perform the new
selected programme.
SELECT THE SPIN SPEED, RINSE HOLD OR
NO SPIN OPTION
Select the spin speed, Rinse Hold option or No
Spin option by turning the spin speed selector.
START/PAUSE starts
to switch the machine off.
Compartment for powder or liquid de-
tergent used for main wash. If using
liquid detergent, pour it just before
starting the programme.
Compartment for liquid additives (fab-
ric conditioner, starch).
Any fabric softener or starching addi-
tives must be poured into the com-
partment before starting the wash pro-
gramme.
Maximum level for quantity of liquid
additives.
• The position 1300 rpm for Cotton is equivalent
to 900 rpm for the Synthetic and Wool
programmes and 700 rpm for the Delicate wash
programme.
Rinse hold
By selecting this option the water of the last rinse is
not emptied out to prevent the fabrics from
creasing. When the programme has finished, the
lights D and E are lit to indicate that the water must
be emptied out (See: 'At the end of the
programme').
No spin
By selecting this option all the spinning phases are
excluded. To be used for extremely delicate
material. The machine will add some additional
rinses to the cotton and synthetic programmes.
For the maximum spin speed allowed by each
programme, refer to the chapter 'Programme
Chart'.

SELECT THE DELAY START

Before you start the programme, if you wish to
delay the start, press the button Delay Start
repeatedly, to select the desired delay. The light
corresponding to the set delay lights up.
). This quantity will
13