Zanussi ZDT200 User Manual page 19

156997470en.qxp 12/27/2006
The dishes are not clean
The dishes are wet and
dull
There are streaks, milky
spots or a bluish coating
on glasses and dishes
Water drops have dried
onto glasses and dishes
If after all these checks, the problem persists,
contact your local Service Force Centre,
quoting the model (Mod.), product number
(PNC) and serial number (S.N.).
This information can be found on the rating
plate located on the side of the dishwasher
door (see picture).
So that you always have these numbers at
hand, we recommend you to make a note of
them here:
Mod. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PNC : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4:35 PM Page 19
The wash results are not satisfactory
The wrong washing programme has been selected.
●
The dishes were arranged in such a way as to stop water reaching all parts
●
of the surface. The baskets must not be overloaded.
The spray arm do not rotate freely due to incorrect arrangement of the load.
●
The filters in the base of the washing compartment are dirty or incorrectly
●
positioned.
Too little or no detergent has been used.
●
Where there are limescale deposits on the dishes; the salt container is
●
empty or the incorrect level of the water softener has been set.
The drain hose connection is not correct.
●
The salt container cap is not properly closed.
●
Rinse aid was not used.
●
The rinse aid dispenser is empty.
●
Decrease rinse aid dosing.
●
Increase rinse aid dosing.
●
The detergent may be the cause, Contact the detergent manufacturer's
●
consumer care line.
19