Zanussi ZDT200 User Manual page 10

156997470en.qxp 12/27/2006
Setting the water softener electronically (see table)
The water softener is factory set at position 5.
1. The dishwasher must be switched off.
Switch on the dishwasher by pressing the On-Off
button.
2. Press and hold Programme/Cancel button until
programme light A flashes and programme light
B illuminates with fixed light.
3. Wait until programme light B turns off,
programme light A goes on flashing and
simultaneously End of cycle light starts flashing.
The number of flashes of the End of cycle light
corresponds to current level set.
The End of cycle light might flash 5 times, for
example. The flashing is repeated every 5
seconds.
10
4:35 PM Page 10
4. To change the level, press the
Programme/Cancel button. Each time the button
is pressed the level increases. (Level 1 follows
level 10). The End of cycle light indicates the
new setting.
5. TTo memorise the operation, switch off the
dishwasher by pressing the On-Off button.