Table of Contents
Advertisement
Section 7
If one of the following indications is displayed
When any of the following indications appears on the copy quantity/magnification display, perform the corresponding procedure.
Indication
"E07" appears on the copy quantity/
magnification display
"E11" appears on the copy quantity/
magnification display
"E12" appears on the copy quantity/
magnification display
"E31" appears on the copy quantity/
magnification display
"E32" appears on the copy quantity/
magnification display
"E70" appears on the copy quantity/
magnification display
"E71" appears on the copy quantity/
magnification display
TROUBLESHOOTING
The size of paper registered in the default settings is different than the
size of the paper actually used. Check the paper size.
Pull out the corresponding drawer and then push it back in to delete the
error indications.
The Paper Feeder was selected, but the upper drawer is not installed or is
not inserted properly.
Push the upper drawer securely into the copier.
When printing out a list or report, there was no 8
paper available.
Press the Paper Select key to select the source of paper feed and then
press the Start key. Print out will be performed onto paper from the
selected location.
The amount of waste toner in the copier has reach the acceptable limit.
Contact your service representative or an authorized service center.
The toner container is not installed in the copier.
Install the toner container.
If the optional Document Processor is installed on your copier, there are
originals remaining on the original table.
Remove the originals, reset them on the original table and try to copy
again.
The copier will attempt to make copies from any originals that remain
uncopied.
Reset all of the originals on the original table and try to copy again.
Procedure
" × 11" or A4 size
1/2
Reference
Page
3-1
—
—
—
8-2
—
—
7-1
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
