Installation; Transit Devices - Zanussi WIJ1074 Instruction Booklet

Transit devices

All transit bolts and packing must be
removed before using the appliance.
You are advised to keep all transit devices so
that they can be refitted if the machine ever has
to be transported again.
1. Using a spanner, unscrew and remove the
rear right-hand bolt.
2. Lay the machine on its back, taking care not
to squash the hoses. This can be avoided by
placing one of the corner packing pieces
between the machine and the floor.
3. Remove the polystyrene base and take off
the bottom panel by unscrewing the central
screw.
4. Carefully remove the right-hand bag.
5. Carefully slide out the other bags.
6. Re-fit the bottom panel using the 4 screws
supplied with the door hinges (in the plastic
bag) and the previously removed screw.
7. Set the machine upright and remove the two
remaining bolts from the back.
8. Pull out the three plastic pegs from the holes
into which the bolts were fitted.
9. Plug the open holes with the plugs which you
will find in the plastic bag containing the
instruction booklet.
74

INSTALLATION

P0255
P0457
P0016
P0256
P0015
P0453
P0020