Hydraulic Connection - Zanussi FA581 User Manual

Hydraulic connection

There should be a COLD WATER tap near the
washing machine with a screwing on connection pipe
of 3 ⁄ " gas for the water supply, a sink, a wash basin
4
or a drainage system in the wall.
Previously check if:
— it is not a hot water tap.
— the running water is clean. If not, run off a
reasonable amount of water to flush out any
debris that may have collected in the pipes.
Have the permanent drainage system in the wall
checked by a plumber.
A
AL013
A) Place the enclosed
rubber joint, delivered in
a plastic bag together
with the appliance (A)
Fig.6), at the very end of
the inlet hose and
carefully screw the pipe
to the tap taking care not
to damage the
screwdrive and fix the
nut well on to the end in
order to avoid leaking.
P0021
15
B) If necessary turn the
hose adequately by
unscrewing the nut at the
rear of the appliance.
C) Now tighten the nut
anew to avoid leaks.
(Open the tap and asure
that it does not leak and
close it again.)
D) Place the discharging
hose in a washbasin or
sink with the aid of the
bent piece delivered
separately. The bent piece
has to be entered into the
tube's mouth in order to
assure the support.
Aforesaid piece allows the
hose to be fixed to the
wall by means of an
opening on the upper part
and that way the hose
does not move and its
falling is avoided.