Table of Contents
Advertisement
PRE-INSTALLATION
PREPARATION
Continued
FRAMING
1. Frame appliance enclosure as illustrated in Figures 7 and 8.
Note: If a wall covering is used to line the enclosure, then all
measurements must be from the surface of the covering.
2. Place the appliance into the framing and secure it.
Note: If appliance is to be raised above floor level, a platform
must be built to support the appliance.
3. Install the supply line to the appliance using a 1/2" NPT black
iron gas line terminating 2
ance. The gas line may be installed from either side or from
the rear of the appliance (see Figure 19, page 11).
4. Feed flexible gas line through one of three gas line conduit
sleeve and repack insulation to cover any openings. Prepare
the incoming gas line with teflon tape or pipe joint compound
and hook-up incoming gas line to the flexible gas line.
Note: If 1/2" NPT black iron pipe does not mate with fitting at
the end of flexible gas line, remove fitting and replace with a
37 degree flare 3/4"-12, 1/2" NPT (female) fitting.
WARNING: When finishing appliance, do not overlap
combustible material onto the black front face. Brick, tile,
or other noncombustible materials may be applied to the
face provided that any gap is between the material used
and the face is caulked with a noncombustible caulking.
16
3
34
/
Figure 7 - Rough Opening for Installing in Wall
108660-01D
5
/
" above the bottom of the appli-
16
1
/
"
8
"
4
For more information, visit www.desatech.com
For more information, visit www.desatech.com
PRE-INSTALLATION PREPARATION
3
39
/
"
8
Figure 8 - Corner Installation Guidelines
5
36
/
"
8
Framing
These Dimensions Allow for a
3/4" Clearance at Sides and
Back of Fireplace. However, 0"
Clearance is Permitted
12"
3
16
/
"
4
5
55
/
"
8
1
34
/
"
2
7 7
16"
3/4" Clearance
Not Required
at Nailing
Flanges
Hide quick links:
Advertisement
Table of Contents
