Yamaha FZ6-NA Owner's Manual page 21

distance traveled from that point. In that
case, pushing the "SELECT" button
switches the display between the vari-
ous tripmeter and odometer modes in
the following order:
TRIP F → E → ODO → TRIP 1 → TRIP
2 → TRIP F
To reset a tripmeter, select it by push-
ing the "SELECT" button, and then
push the "RESET" button for at least
one second. If you do not reset the fuel
reserve tripmeter manually, it will reset
itself automatically and the display will
return to the prior mode after refueling
and traveling 5 km (3 mi).
Clock mode
1. Clock
INSTRUMENT AND CONTROL FUNCTIONS
To switch the air intake temperature
display to the clock, first set the display
to the odometer or tachometer mode,
and then push the "RESET" button for
at least two seconds.
NOTE:
The clock is automatically displayed
when the key is turned to "OFF".
To set the clock:
1. Push the "SELECT" button and
"RESET" button together for at
least two seconds.
2. When the hour digits start flashing,
push the "RESET" button to set the
hours.
3. Push the "SELECT" button, and
the minute digits will start flashing.
4. Push the "RESET" button to set
the minutes.
5. Push the "SELECT" button and
then release it to start the clock.
3-7
Air intake temperature mode
1. Air intake temperature display
The temperature displayed may vary
from the outside temperature depend-
ing on engine conditions. To switch the
clock to the air intake temperature
mode, first set the display to the odom-
eter or tachometer mode, and then
push the "RESET" button for at least
two seconds.
3