Yamaha Venture XVZ13TFV Owner's Manual page 51

tunes in the first station that has a
strong enough signal to be re-
ceived.
Tuning in a radio station manually
In order to tune in a particular radio sta-
tion (e.g., when the signal is too weak
for automatic tuning), the radio frequen-
cy can be selected manually as follows.
1. Select a frequency band. (See the
"Selecting a frequency band" sec-
tion.)
2. Repeatedly push the "SELECT"
button for less than one second
until the currently selected radio
frequency appears in the display.
3. Push either side of the up/down
switch for less than one second
until the desired frequency is dis-
AUDIO SYSTEM AND CB RADIO
played. The frequency changes in
0.2-MHz steps for FM and in 10-
kHz steps for AM.
Tuning in a preset radio station
1. Preset station number
1. Select a frequency band. (See the
"Selecting a frequency band" sec-
tion.)
2. Repeatedly push either side of the
up/down switch for less than one
second until the desired preset
station number is displayed.
NOTE:
To be able to tune in a preset radio sta-
tion, you must have previously pro-
grammed at least one. (See the
following sections.)
4-13
Programming preset radio stations
manually
Up to six stations can be programmed
for each frequency band (FM1, FM2,
FM3, and AM) using either manual or
automatic tuning.
Using manual tuning
1. Manually tune in a radio station
that you wish to preset. (See the
"Tuning in a preset radio station"
section.)
2. Push the "SELECT" button once
for two seconds or more. The radio
frequency and preset station num-
ber "1" (to the right of "CH.") start
flashing.
4