Making Mode Settings - Yamaha Venture XVZ13TFS Owner's Manual

Making mode settings

General procedure
The following setting procedure applies
to the audio system, CB radio, and op-
tional CD changer.
NOTE:
G
In order to make settings in any of
the audio system modes, make
sure that the audio system is se-
lected. If necessary, push the "AU-
DIO" button for less than one
second.
G
In order to make settings in the CB
radio modes, make sure that the
CB radio is selected. If necessary,
push the "CB" button for less than
one second.
1. Repeatedly push the "SELECT"
button for less than one second
until the desired mode appears in
the display. With each press of the
button, the mode changes in the
following sequence.
EAU15502 Audio system
BASS
SP/HS
(Output)
AV
Radio
2
frequency (Auto
volume)
1
This mode does not appear in the display when
the headsets are selected as the output.
2
This mode appears in the display only when one
of the radio frequency bands is selected as the au-
dio source.
CB Radio
IC (Intercom volume)
SP/HS
(Output)
RB: on/oF (Roger beep)
2. While the selected mode is dis-
played (for about five seconds), re-
peatedly push either side of the
up/down switch for less than one
second until the desired setting is
displayed.
AUDIO SYSTEM AND CB RADIO
Selecting the output (speakers or
headsets)
FAD
TREB
1
(Treble) (Fade )
IC
(Intercom
volume)
1. Repeatedly push the "SELECT"
2. Push either side of the up/down
NOTE:
The speakers and headsets cannot be
used at the same time.
4-6
button for less than one second
until either "SP" (speakers) or "HS"
and " " (headsets) appears in the
display.
switch for less than one second to
change the setting.
4