Yamaha Star XV17PCX Owner's Manual page 66

PERIODIC MAINTENANCE AND MINOR REPAIR
To adjust the drive belt slack
1. Loosen the axle nut and the brake
caliper bracket bolt.
1. Axle nut
6
1. Brake caliper bracket bolt
2. Loosen the locknut on each side of
the swingarm.
EAU23080 3. To tighten the drive belt, turn the
adjusting bolt on each side of the
swingarm in direction (a). To loos-
en the drive belt, turn the adjusting
bolt on each side of the swingarm
in direction (b), and then push the
rear wheel forward.
NOTE:
Using the alignment marks on each
side of the swingarm, make sure that
both belt pullers are in the same posi-
tion for proper wheel alignment.
1. Locknut
2. Drive belt slack adjusting bolt
3. Alignment marks
6-27
CAUTION:
Improper drive belt slack will over-
load the engine. Keep the drive belt
slack within the specified range.
4. Tighten the locknuts, the axle nut
and the brake caliper bracket bolt
to the specified torques.
Tightening torques:
Locknut:
16 Nm (1.6 m·kgf, 11 ft·lbf)
Axle nut:
150 Nm (15.0 m·kgf, 110 ft·lbf)
Brake caliper bracket bolt:
30 Nm (3.0 m·kgf, 22 ft·lbf)
ECA10880