Table of Contents
Advertisement
E_8gg.book Page 16 Thursday, March 16, 2006 4:23 PM
8. Install the V-belt over the primary sheave assembly.
9. Rotate the secondary sliding sheave clockwise 6
and push 7 it so that it separates from the secondary
fixed sheave.
10. Install the V-belt 8 between the secondary sliding
and secondary fixed sheaves.
11. Install the drive guard.
WARNING
@
Never run the engine with the V-belt or drive guard
removed.
@
ESU03514
Checking the drive chain housing oil level and
the drive chain tension
Checking the oil level
WARNING
@
The engine, oil tank, brake disc, and coolant hoses
will be very hot after the engine has been run. Avoid
contact while they are still hot with any part of your
body or clothing during inspection or repair.
@
1. Place the snowmobile on a level surface.
2. Remove the dipstick 1, wipe it off with a clean rag,
and then insert it back into the filler hole.
8-16
Advertisement
Table of Contents
