Headlight Beam Switch; Auxiliary Dc Jack - Yamaha RS90NW Owner's Manual

E_8gg.book Page 10 Thursday, March 16, 2006 4:23 PM
ESU00039

Headlight beam switch

Push the headlight beam switch to change the headlight
beam to high or low.
1 Headlight beam switch
2 Push
3 High beam
4 Low beam
ESU04301

Auxiliary DC jack

For RS90GT/RSG90GT
The auxiliary DC jack is located in the front panel and
can be used for accessories.
NOTE:
@
The auxiliary DC jack cannot be used if the engine is not
running.
@
1. Start the engine.
2. Open the auxiliary DC jack cap 1, and then insert
the accessory power plug into the jack 2.
NOTE:
@
After using the auxiliary DC jack, be sure to remove the
accessory power plug from the jack and close the auxil-
iary DC jack cap.
@
CAUTION :
@
G Do not use accessories requiring more than the
maximum rated capacity for the auxiliary DC jack.
This may overload the circuit and cause the fuse
to blow. (See pages 8-37–8-39 for the specified
amperage.)
G
Do not use an automotive cigarette lighter or
other accessory with a plug that gets hot
because the jack can be damaged.
@
Maximum rated capacity:
DC 12 V, 2.5 A (30 W)
5-10