Zanussi Electrolux ZWD 14581 W User Manual page 34

132972390.qxd 18/06/2007
The drain hose may be extended to a
maximum of 4 metres. An additional drain hose
and joining piece is available from your local
Service Force Centre. The joining piece must
have an internal diameter of 18mm.
2. Onto a sink outlet spigot.
If the outlet spigot has not been used before,
remove any blanking plug that may be in place.
Push the drain hose onto the spigot and secure
with a clip if required, ensure a loop is formed
in the drain hose (see diagram) to prevent
waste from the sink entering the washer-dryer.
Important!
Before connecting the machine to new
pipework or to pipework that has not been
used for some time, run off a reasonable
amount of water to flush out any debris that
may have collected in the pipes.
Levelling
34
14:07 Pagina 34
If your drain hose
looks like this (see
below) you do not
require the «U» piece.
Just push the hose
firmly into the
standpipe.
Level the washer-dryer by raising or lowering
the feet. The feet may be tight to adjust as they
incorporate a self locking nut, but the machine
MUST be level and stable.
Any necessary
adjustment can be
made with a spanner.
Accurate levelling
prevents vibration,
noise and
displacement of the
machine during operation.
Some vibration is inevitable, especially if
mounted on a wooden floor.
Sprung wooden floors are particularly
susceptible to vibration. For advice, consult a
builder. If possible, always place the machine
on a solid floor.
Special conditions
If the floor is carpeted or covered with crumbly
or soft material, insert a rigid support base
under the feet to prevent noise, vibration or
displacement. The base should protrude a few
centimetres beyond the edges of the machine.
WARNING!
The machine should NOT be placed on deep
pile carpeting.
NOTE
Please ensure that when the appliance is
installed it is easily accessible for the engineer
in the event of a breakdown.
In the interest of the environment
washer-dryers and dishwashers should be
connected to the FOUL drainage system, the
water will then be taken to a sewage works for
treatment before being discharged safely into a
river. It is essential that these appliances are
not connected to the surface water drainage
system as this water is discharged directly into
a river or stream and may cause pollution.