Operating Sequence; Washing - Zanussi Electrolux ZWD 14581 W User Manual

132972390.qxd 18/06/2007

Operating sequence

as much as possible. Close the door.
2. Measure out the detergent and the fabric
softener
Pull out the dispenser drawer until it stops.
Measure out the amount of detergent required,
pour it into the main wash compartment
and, if you wish to carry out the prewash
phase, pour it into the compartment marked
.
If required, pour fabric softener into the
compartment marked
must not exceed the «MAX» mark in the
drawer). Close the drawer gently.
3. Select the required programme
The selector dial is divided into the following
sections:
Jetsystem+ (Proportional programmes),
●
Cottons (Normal programmes),
●
14:06 Pagina 17
1. Load the laundry
Open the door by
carefully pulling the
door handle outwards.
Place the laundry in the
drum, one item at a
time, shaking them out
(the amount used
Synthetics,
●
Delicates,
●
Special,
●
Drying
●
The green Start/Pause light starts to flash.
The selector dial can be turned either
clockwise or anticlockwise.
Position «Off» to Reset programme/Switching
OFF of the machine.
At the end of the programme the selector
dial must be turned to position «Off», to
switch the machine off.
IMPORTANT!
If you turn the programme selector dial to
another programme when the machine is
working, the red Start/Pause pilot light will
flash 3 times and the message Err is displayed
on the display to indicate a wrong selection.
The machine will not perform the new selected
programme.
4. Select the temperature
Press this button repeatedly to increase or
decrease the temperature, if you want your
laundry to be washed at a temperature different
from the one proposed by the washing
machine.Maximum temperatures are 95°C for
Cottons, 60°C for Synthetics, 40°C for Easy Iron,
Delicate, Handwash, 30°C for Silk, Duvet and
Mini 30', while corresponds to cold wash.
17