Chapter 3 - Installing The Yamaha Cdr400Atx Chapter 3 - Drive; Cdr400Atx Drive Settings - Yamaha CDR400Atx Series User Manual

Chapter 3 - Installing the Yamaha CDR400Atx Drive
Chapter 3 - Installing the Yamaha CDR400Atx Drive

CDR400Atx drive settings

SCSI ID settings
The SCSI ID number is used so that the computer will recognize a
connected SCSI device. You can assign 0 through 7 as the SCSI ID
number. Usually, "7" is reserved for the SCSI card ID number, and
"0" is reserved for the first SCSI device in the chain. Use a number
between 1 and 6 for the CDR400Atx.
Use the switch on the rear panel to set a SCSI ID number. The factory
set ID number is "1".
Caution: If you are using other SCSI devices, be sure to use a unique ID number
for each device. Be sure to turn off the power to the drive before you set
the SCSI ID number.
Note: When you are using Windows 95, and if the SCSI ID setting on the rear
panel is the same as the number assigned to another SCSI device, the
Plug and Play component of Windows 95 will automatically assign an
unused number to the CDR400Atx (SCAM protocol level 1).
Terminator setting
The terminator setting indicates whether or not this device is the last
connected SCSI device.
Terminator ON
TERMINATOR
Terminator OFF
TERMINATOR
8
— Use this setting if the CDR400Atx is the last device in
the SCSI daisy-chain.
OFF ON
— Use this setting if devices other than the CDR400Atx
are in the SCSI daisy-chain and the CDR400Atx is not
OFF ON
the last device.
Pressing this switch repeatedly
will decrease the SCSI ID
number by one each time.
SCSI ID Number
Pressing this switch repeatedly
will increase the SCSI ID
number by one each time.