Chapter 1 - System Configuration; Computer; Software - Yamaha CDR400Atx Series User Manual

Chapter 1 - System Configuration

Chapter 1 - System Configuration
In order to use the CDR400Atx, you will require the following.

Computer

The following operating environment is required:
For an IBM-PC computer with DOS or Windows
•
•
•
•
Note: You will need about twice as much space on your hard disk as that
required by the data you wish to write to CD-ROM.
SCSI card
This is required in order to connect a SCSI device (the Yamaha
CDR400Atx) to your computer.
We recommend the following:
Adaptec SCSI cards: AHA-2940 (PCI), AHA-284x (VL), AHA-2740
(EISA), AHA-154x (ISA), etc.
For a Macintosh computer
•
Note: You will need about twice as much space on your hard disk as that
required by the data you wish to write to CD-ROM.

Software

Use writing software or packet writing software which supports the
CDR400Atx or CDR400t.
4
An IBM/AT compatible computer with a 100 MHz or faster Pentium
CPU (in order to write at 4x speed), or a 100 MHz or faster 486
CPU (in order to write at 2x speed)
A vacant slot in which to install a SCSI card or a pre-installed
SCSI card
Windows 95, Windows NT4.0 or Higher
Sufficient hard disk space
A Macintosh computer that is equipped with a 68040 CPU, or a
Power PC CPU