Chapter 3 - Installing The Yamaha Cdr400Tx Drive; Cdr400Tx Drive Settings - Yamaha CDR400tx User Manual

Chapter 3 - Installing the Yamaha CDR400tx Drive

Chapter 3 - Installing the Yamaha
CDR400tx Drive

CDR400tx drive settings

SCSI ID settings
The SCSI ID number is used so that the computer will recognize a
connected SCSI device. You can assign 0 through 7 as the SCSI ID
number. Usually, "7" is reserved for the SCSI card ID number, and
"0" is reserved for the first SCSI device in the chain. Use a number
between 1 and 6 for the CDR400tx.
Use the switch on the rear panel to set a SCSI ID number. The factory
set ID number is "1".
Caution: If you are using other SCSI devices, be sure to use a unique ID num-
ber for each device. Be sure to turn off the power to the drive before
you set the SCSI ID number.
Note: When you are using Windows 95, and if the SCSI ID setting on the
rear panel is the same as the number assigned to another SCSI device,
the Plug and Play component of Windows 95 will automatically
assign an unused number to the CDR400tx (SCAM protocol level 1).
Terminator setting
The terminator setting indicates whether or not this device is the last
connected SCSI device.
Terminator ON
TERMINATOR
Terminator OFF
TERMINATOR
8
— Use this setting if the CDR400tx is the last device in the
SCSI daisy-chain.
OFF ON
— Use this setting if devices other than the CDR400tx are
in the SCSI daisy-chain and the CDR400tx is not the
OFF ON
last device.
Pressing this switch
repeatedly will decrease the
SCSI ID number by one each
SCSI ID Number
Pressing this switch repeatedly
will increase the SCSI ID number
by one each time.