Yamaha AR210 Owner's/Operator's Manual page 56

3
O
PERATION
NOTE: Before the first start-up, remove
the fuel tank filler cap to release any
built-up pressure in the tank because
of fuel expansion.
2) Attach the engine shut-off cord to
your PFD. Install the cord clip onto
the engine shut-off switch by push-
ing the clip groove over the nut
beneath the knob. Be sure the cord
is not wrapped around the steering
wheel or tangled in the controls.
1
Engine shut-off switch
2
Clip with cord
NOTE: It is not possible to start the
engine with the clip removed from the
engine shut-off switch. However, the
starter motor will turn the engine over.
3) Pull the choke knob all the way out.
NOTE:
It may be necessary to hold the
choke knob completely pulled out
when starting a very cold engine.
After the engine has warmed up,
push the choke knob in gradually.
The choke should not be used when
the engine is warm.
3-14
1
2