Yamaha YZF600RT Owner's Manual page 80

PERIODIC MAINTENANCE AND MINOR REPAIR
2. Remove the front fender by remov-
ing the screws.
3. Loosen the front wheel axle pinch
bolt, then the wheel axle and the
brake caliper bolts.
1. Front fender
6
2. Screw
3. Front wheel axle pinch bolt
4. Wheel axle
5. Bolt
6. Brake caliper
7. Brake hose holder
4. Lift the front wheel off the ground
according to the procedure on
page 6-38.
5. Remove the brake hose holders
on each side by removing the bolt
and nut.
6. Remove the brake calipers on
each side by removing the bolts.
7. Pull the wheel axle out, remove the
speedometer gear unit, and then
remove the wheel.
CAUTION:
Do not apply the brake after the
brake calipers have been removed,
otherwise the brake pads will be
forced shut.
To install the front wheel
1. Install the speedometer gear unit
into the wheel hub so that the pro-
jections mesh with the slots.
2. Lift the wheel up between the fork
legs.
NOTE:
Make sure that the slot in the speedom-
eter gear unit fits over the retainer on
the fork leg.
6-39
ECA11050
1. Speedometer gear unit
2. Slot
3. Speedometer gear unit retainer
EAU24851
3. Insert the wheel axle.
4. Lower the front wheel so that it is
on the ground.
5. Install the brake calipers by install-
ing the bolts.
NOTE:
Make sure that there is enough space
between the brake pads before install-
ing the brake calipers onto the brake
discs.
6. Install the brake hose holders by
installing the bolts and nuts.