Yamaha XA1200Ltd WaveRunner Owner's/Operator's Manual page 69

3) Attach the lock-plate
stop lanyard switch
lanyard to your left wrist.
WARNING
Check that the lanyard is not frayed or
broken, wrapped around the handlebar,
or tangled in controls. If the operator
falls off, the vehicle could continue to run
and cause an accident. The operator and
passenger(s) would also be unable to
reboard the vehicle, which increases the
chance of being hit by another boat and
the risk of the exposure.
NOTE:
It is not possible to start the engine with the
lock-plate removed from the engine stop
lanyard switch.
4) Pull the choke knob all the way out to
start a cold engine.
NOTE:
The choke should not be used when the
engine is warm.
5) If the "LOCK" mode was chosen previ-
ously, chose the "START" mode before
starting the engine. To set the mode,
refer to "PADLOC" in "MULTIFUNCTION
METER".
NOTE:
● If initial setting of the PADLOC has not
been done, the "START" mode is auto-
matically selected.
● If you have previously chosen "LOCK"
mode, the engine will not start unless the
right code is put in to select "START"
mode.
3-13
E
to the engine
. Also attach the