Rear Wheel - Yamaha VIRAGO XV250P Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
Tightening torque:
Front wheel axle pinch bolt:
20 Nm (2.0 m·kgf, 14 ft·lb)
8. Connect the speedometer cable.
6
1. Brake torque rod
2. Brake torque rod cotter pin
3. Brake torque rod bolt
4. Brake rod
5. Brake pedal free play adjusting nut
6. Brake cam shaft lever

Rear wheel

To remove the rear wheel
WARNING
_
It is advisable to have a Yamaha
dealer service the wheel.
Securely support the motor-
cycle so that there is no danger
of it falling over.
_
6-36
1. Remove the axle nut cotter pin
and the brake torque rod cotter
pin.
2. Loosen the axle nut and the brake
torque rod nut at the brake shoe
plate.
3. Lift the rear wheel off the ground
according to the procedure on
page 6-34.
4. Disconnect the brake torque rod
from the brake shoe plate by re-
moving the nut and the bolt.
5. Remove the brake pedal free play
adjusting nut, and then disconnect
EAU01550*
the brake rod at the brake cam-
shaft lever.
EW000122