XSAT CD.TV410 Manual page 13

SWITCHING ON THE CD.TV410
RECEIVER
Turn on the television. Select an "AV"
or "AUX" program (refer to the television
instructions). Plug in the CD.TV410
receiver, which then initialises (INIT). The
XSAT logo will then appear on the tele-
vision. If your receiver has not yet been
configured, it will display a series of
screens to guide you through the initial
configuration. If your receiver goes into
standby mode when turned on, either
press the button on the front or on the
remote-control.
CD.TV410 RECEIVER
CONFIGURATION
When first turned on, your CD.TV410
receiver will guide you through the
configuration, by displaying the neces-
sary menus.
AND FIRST-TIME USE
Antenna
Tone Burst monobloc double head
Hotbird
Local Time configuration
To configure local time, the difference
between local time and Greenwich Mean
Time (GMT) has to be indicated. In the
United Kingdom, select GMT+1 during
the summer and GMT in winter.
Installation configuration
Installation is summarised in detail on
only one screen.
First select your own configuration using
the
are:
- Standard LNB : use of one dish with
one LNB ; allows you to receive one
satellite.
- Tone Burst monobloc double head :
only one dish with a monobloc double
head to receive two close satellites
(e.g: Astra and HotBird in Europe).
CONNECTION
Astra
Save
buttons. Standard configurations
5
41