Trac Offset; Trac Inhibit - Whites DXF Manual

AUTO TRAC OFFSET
+ 0
MIN MAX
Tips - Recommended only
for experienced operators
who fully understand
ground rejection. Settings
from -10 - +10 are
available.

TRAC INHIBIT

ON
OFF
TO CHANGE PRESS ENTER
Tips - ON for most search
conditions, OFF for pros-
pecting.
Chapter 5 DFX
(G.E.B./Trac section)

9. Trac Offset

®
Allows AUTOTRAC
either positive or negative in relationship to the
correct setting (under, or over kill).
TRAC OFFSET allows the AUTOTRAC
to track the ground slightly more or less than what
would normally be considered perfect, mostly for
experts that prefer a slight offset.
A slightly positive offset can be used to enhance
the responses of small metals (gold nuggets) in
highly-mineralized ground. Positive is indicated by
a slight increase in threshold as the loop ap-
proaches the ground in the all-metal mode. Dis-
crimination and depth may also be improved.
A negative offset may be used to eliminate particu-
larly troublesome "hot rocks" in areas that are
otherwise difficult to search. Negative offset is
indicated by a loss or slight decrease in the thresh-
old as the loop approaches the ground in the all-
metal mode.
(G.E.B./Trac section)
10. Trac Inhibit
Prevents AUTOTRAC
during target detection.
TRAC INHIBIT ON prevents the AUTOTRAC
feature from altering Ground Balance during the
detection of targets. This prevents the possibility
of tracking to the corrosion associated with most
metals. TRAC INHIBIT ON is recommended for
most searching conditions. Some metals do not
corrode (GOLD) and since tracking is extremely
important in high mineral conditions, the ability to
turn TRAC INHIBIT OFF is available. OFF is
automatically selected in the Prospecting Program
and is recommended for prospecting.
™ Pro Options
to track ground minerals
®
feature
®
from tracking the ground
®
33