Accumulate; Average - Whites DXF Manual

Chapter 5 DFX
If ACCUMULATE is OFF, and AVERAGE
is OFF, then SINGLE SWEEP is active.
SINGLE SWEEP displays SignaGraph
information received during the current sweep
of the loop, no more and no less. The next
sweep of the loop will clear all information
from the SignaGraph
received only within that sweep. Fade is not
needed in the SINGLE SWEEP mode as each
pass of the loop will clear the display and
provide current information automatically.
Several SignaGraph
occur during each sweep of the loop. It is
therefore normal to see one or more
®
SignaGraph bars, even in the SINGLE
SWEEP mode.
48
™
Pro Options
GRAPH ACCUMULATE
ON
OFF
TO CHANGE PRESS
ENTER
Tips - ON is suggested,
since it takes several
sweeps of information to
recognize trends.
®
®
and list the information
®
indication samples
GRAPH AVERAGING
ON
OFF
TO CHANGE PRESS
ENTER
Tips - Most beneficial
when used in combination
with ACCUMULATE.
AVERAGE ON is sug-
gested as it reduces
indications uncharacteris-
tic of a particular target,
which may occur due to
loop angle or target
positioning in the ground.
(Display section)

26. Accumulate

ON combines SignaGraph
multiple loop passes, OFF shows SignaGraph
information only from the last sweep of the loop.
Accumulate allows the SignaGraph
collect information. This collecting of information
continues from one sweep of the loop to the next.
Eventually, if only ACCUMULATE is selected,
®
the SignaGraph will completely fill, requiring that
the TRIGGER be squeezed and released to clear it
so that further information may be viewed. FADE
is suggested to be used in combination with ACCU-
MULATE so that noncurrent information gradually
disappears and excessive TRIGGERing is not
required. FADE will gradually reset or clear the
®
SignaGraph to eliminate old information.
(Display section)

27. Average

Emphasizes the most common or predominate
®
SignaGraph indications.
AVERAGE does not necessarily allow showing of
all the available information on the SignaGraph
averages the information received, and shows this
average on the SignaGraph
nation with ACCUMULATE it has more informa-
tion to average, which results in more accurate
indications of trends. FADE is suggested to clear
the display of old information, rather than excessive
TRIGGERing.
®
information over
®
®
to continually
®
®
. When used in combi-
. It