GETTING STARTED
L1
RINGER LEVEL
L2
OFF
L 2
OFF
HIGH
LOW
LOW
BASE RINGER
SWITCH
TELEPHONE
WALL JACK
-
+
DC IN 9V
L1/L1+L2
LINE 2
WALL
TELEPHONE
WALL JACK
-
+
DC IN 9V
L1/L1+L2
LINE 2
LINE 2
DIAL MODE
PULSE
TONE
HIGH
TONE/PULSE SWITCH
L2
LINE 2
DC
TELEPHONE
WALL JACK
L2
DC
•
Set the TONE/PULSE switch, located on
the antenna side of the Base Unit, to the
desired dialing mode. In most areas, TONE
is the desired mo
•
After charging the battery pack, connect
the telephone line(s)
1. If you have 2 lines coming out of
a single wall jack:
Connect a 4-wire (RJ-14) phone cord be-
tween the wall jack and the phone jack la-
beled L1 / L1+L2 .
If you are wall mounting your Base Unit, a
short, 4-wire phone is provided for your
convenience
2. If you have 2 lines, each coming
out of a separate wall jack:
Connect a phone cord from the wall jack
you wish to designate as your LINE1, to
the L1 / L1+L2 jack on the back of the
phone; next, connect a phone cord from
the remaining wall jack to the L2 jack on
the phone.
NOTE: You can use your VT2931 as a one-
line phone, as well. For best results, raise
the antenna on the Handset and Base Unit
when using your telephone.
5
de.