INTRODUCTION FOR YOUR SAFETY Warnings and Safety Advice Coolant WARRANTY AND CUSTOMER SERVICE INSTALLATION The Purpose of this Manual Tools/Materials Required Unpacking Cleaning Installation Securing Connecting the Device to the Electricity Supply Changing the Sliding Hinge Changing the Doorhang 4.10 Decor Panel INSTRUCTION FOR USE Initial Operation Temperature Control...
Any damage due to improper use is not covered by the warranty. The warranty does not cover any modifications to the appliance or the use of non-original Dometic parts; the warranty does not apply if the installation and operating instructions are not adhered to and no liability shall be entertained. Parts can be ordered throughout Europe from our Dometic service department.
MLC-Code and serial number ! You can find this information on the model label inside the device. e.g. H H i i P P r r o o 3 3 0 0 0 0 0 0 4 4 . . 0 0 INSTALLATION The Purpose of this Manual The manual shows you how to:...
Installation 200 cm² 20 mm IMPORTANT: Please follow the installation details below carefully. Guarantee is valid for products installed as described only. 1. The refrigerator must be level both directions. 2. There should be 20mm clearance to the wall. 3. Ventilation must be provided as shown in alternatives A, B, C or D.
If this is not the case, do not connect the device and contact your dealer! If the connection cable is damaged it must be replaced by the Customer Service at Dometic, or by respectively qualified personnel, in order to pre- vent any hazards.
Page 7
If the fuse cover-carrier is lost, a replaceement can be obtained from the Dometic Service Shops. The fuse cover/carrier must be of the same colour as that of the coloured insert in the base of the plug.
Changing the Sliding Hinge Distance to cupboard door (A) 1. When closed, the cupboard door (A) must not lie against the rest of the surrounding cupboard area (distance 1-2mm). 2. There must be a distance of 6-8mm between the cupboard door and the miniBar.
Changing the Doorhang (optional) LED door-opening con- trol always opposite the hanging side device with feet If the miniBar is equipped with the LED first carry out steps a. - e. : Pull out LED, lay the cable into the cable routing and insert the LED at the oppo- site side.
Remark (devices without doorlock) - Additional installation of a door lock is possible (available from Dometic) - In the door the position for the opening is prepared. - Drill the hole in accordance to the drawing above.
5 5 . . 0 0 INSTRUCTION for USE Initial Operation The device must be plugged into a properly earthed socket. The miniBar starts automatically with a self- test. If the electronics do not detect any fault, the LED for the interior lighting illumi- nates for 2 seconds after approximately 10 seconds.
Positioning of the Storage Rack and Shelf - Pull out the storage rack until it is blocked. - Press in the lock of both running rails. - Remove storage rack and running rails and place it at the desired position. - After clicking in the the storage rack it is secured against pulling out completely again.
Check List Failure : No cooling (the aggregate at the back of the device is cold). Possible Cause Self Help Authorised Service a.) The device plug is not a.) Plug in device plug. plugged in. b.) No voltage in socket. b.) Check main fuse.
Technical Data Model HiPro 3000 Casing Plastic Gross Contents ( litres) cooled / uncooled 28 / - Dimensions (mm) (H x W xD) 527 x 388 x 418 Electrical Rating (W) Power Consumption kWh / 24h* Net Weight (kg) Assembly...
5.11 Environmental Advice miniBars manufactured by Dometic GmbH are free from CFCs / HCFCs and fluorinated hydrocarbons. The cooling unit uses ammonia as the coolant (a natural compound of hydrogen and nitrogen). Cyclopentane, which does not damage the ozone layer, is used as propellant for the insulation made from PU-foam.