Dometic HiPro 3000 Instructions For Use Manual page 7

4.7.1
Plug connection for United Kingdom only
If a 3-pin plug is used, it should be fitted with a 3 amp fuse,
with other plug types, the circuit should contain a 5 amp fuse.
The wires in the mains lead of this appliance
are coloured in accordance with the following
code:
GREEN and YELLOW
BLUE
BROWN
As the colours of the wires in the mains lead
may not correspond with the coloured markings
identifying the terminals in your plug, proceed as
follows.
1. Connect the GREEN and YELLOW coloured wire to the plug terminal
marked letter E or earth symbol or coloured green or green and yellow.
2. Connect the BROWN coloured wire to the plug terminal marked letter L
or coloured red.
3. Connect the BLUE coloured wire to the plug terminal marked letter N or
coloured black.
Moulded-On Plug Version
The mains lead is fitted with a non-rewirable moulded-on plug containing
a 3 amp fuse. If the fuse requires replacing at any time, the fuse
cover/carrier should be removed using a small screwdriver to level out. The
old fuse should be replaced by a 3 amp ASTA approved BS1362 fuse and
the fuse cover/carrier must be refitted before the plug is used again.
If the fuse cover-carrier is lost, a replaceement can be obtained from the
Dometic Service Shops.
The fuse cover/carrier must be of the same colour as that of the coloured
insert in the base of the plug. In no circumstances must the plug be used
without a correct fuse cover/carrier fitted.
If the plug supplied on the mains lead is not suitable for the socket in your
home, it should be cut off and disposed of safely, or destroyed, to avoid any
possible shock hazard resulting from the plug being inserted into a 13 amp
socket elswhere in the use. A suitable replacement plug should then be
fitted as given above.
Attention: For GB only !
Warning - This appliance must be earthed.
IMPORTANT
: EARTH
: NEUTRAL
: LIVE
7